This is a fun little hobby to get into. I always wanted one and now that I have it, I am not disappointed with it at all. Setting it up wasn’t that hard or take that long. There are plenty of videos on YouTube on setting it up and using it along with using LaserGRBL. Did a couple of little engravings to test it and play and learn the software and it isn’t as hard as you may think. You should put something under what you are engraving or burning to make sure you don’t burn whatever is under it, like your table. Make sure it is level as well, so what you are burning is level, so your engraving comes out looking great.
Between this laser engraver and the software, there are so many options and settings, you can do a lot with this and never get bored. Just remember these do not like shiny surfaces and won’t engrave them. Some you may be able to do if you prepare the surface beforehand with paint, Thermark, or Cermark.
DISCLAIMER:
This was offered at a discounted rate in exchange for an honest review. I rely
on reviews from the community when making purchases, so I believe in giving
honest and unbiased reviews to help others. I am not obligated to leave
positive feedback and receive no compensation for doing so. I am not
associated with the seller in any way.
My Rating: 5 Stars
Found on Amazon: https://amzn.to/3nubuw1
As an Amazon Associate, I earn
from qualifying purchases.
No comments:
Post a Comment